Publicité
Les langues disponibles
Les langues disponibles
SPEAKER RECEIVER
1.
Plug in the power adapter with the rock speaker and AC power outlet to charge the
lead acid battery built inside the rock speaker. The battery pack must be charged at
least 15 hours before the first operation.
2.
The rock speaker can be operated either with power supplied by battery pack or from
AC outlet with connection of power adapter. When the power adapter is connected
with AC outlet, the battery pack will be simultaneously charged when the unit is in
operation. Press On/Off button and turn the speaker ON. The POWER LED will
light up in green. Switch off the speaker by pressing the ON/OFF button on the
speaker, and the LED will be off.
Power LED
OPERATION
1.
Turn on the audio source (TV or audio component) to which the transmitter is
connected with. The green LED on the transmitter will light up.
2.
Select the channel (1 or 2) of the transmitter for best performance in your location.
3.
Turn on the ON/OFF button on the speaker. Press the "AUTO TUNE" button to get
the best tuning reception in the speaker. When the button is pressed, frequency
tuning starts automatically and it stops when a signal is detected.
All manuals and user guides at all-guides.com
DC Jack
P.4
4.
Volume can be adjusted up by pressing the "+" button, or down by pressing the
button "-" to the desired listening level.
5.
Should you experience any frequency interference, move your channel switch from
one channel to the other channel (there are two channels for selection) on the
transmitter, and then press the "AUTO-TUNE" button again.
NOTE:
Press the "AUTO TUNE" button for the best reception.
P.5
Publicité
