Télécharger Imprimer la page

Rimage Everest III Manuel D'utilisation page 28

Masquer les pouces Voir aussi pour Everest III:

Publicité

Everest III User Guide
Rimage™ Safety Information
This information and the indications on the product allow proper and safe operation. The indication marks below
help protect you and other persons from injury, and equipment from damage.
Important! Any equipment that has certain components using AC line voltage, or in some cases low DC
voltages, such as power switches, power supplies, fuses, fans, non-stepper motors, must be replaced with
Rimage–approved components to maintain the safety approval issued by UL.
Warning! According to ANSI (American National Standards Institute) standards, a warning is used to
indicate situations that could result in bodily injury to personnel operating or maintaining the equipment.
Caution: Indicates that failu
product, software, or dat
Safety Precautions
To ensure sa
fety, please read these precautions and familiarize yourself with their meaning before using the
equ pment.
i
W ning!
ar
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiant exposure.
The laser beam used by the DVD-R recorder is a Class 2 laser and can be harmf
attempt to open the recorder. An authorized technician should perform all service
The front bezel of the printer can be opened by han
Do not touch the heater roller.
The interior of the printer contains sharp edges.
Do not disassemble or use tools on the printer. All service procedures sh
Rimag
e-authorized technician, or sent in for Rimage-authorized repair.
Do not service the printer with the power cord plugged in the AC outlet.
Cau
tion:
Do not use the printer if it is overheating or an abnormal sm
an electric shock. In case of heating or abnormal smell, immediately disconnect the cable from the
outlet. Co
ntact your Rimage-authorized dealer for repairs.
Allow sufficient free space for opening the printer drawer. Do not touch the printer drawer while it is
moving.
If the side cover is opened while power is supplied, the printer will stop. Do not reach into the printer
while it is operating. Do not attempt to bypass the door interlock.
This printer has no power switch. Power is disconnected completely
recommends installing the printer in a position that allows immediate disconnection of the power cab
Always hold the plug when disconnecting the cable from the outlet.
This printer has a volta
correct voltage. Please do not use any voltage other than 110VAC or 220VAC. This could result in a fire
and an electric shock.
All equipment with AC lin
non-stepper motors, must be replaced with Rimage-approved components to maintain the safety
approval issued by UL.
Use only the supplied AC power cord. For more info
Rimage Customer Service.
This product is designed for an
Country-specific cautions for Wideband Data Transmission systems; 240
France: Do not use outdoors.
Italy: If used outside of
Norway: This subsection does not apply for the geographical area within a radius of 20 km from the
centre of Ny-Alesund.
24
All manuals and user guides at all-guides.com
re to observe this guideline could result in loss or damage to the equipment,
a.
ge slide switch on the back of the unit. Before use, check that it is set to the
e voltage, or low DC voltages, such as switches, power supplies, fuses, fans,
office environment.
own premises, general authorization is required.
d. Do not insert your fingers.
ould be performed by a
ell is detected. This may result in a fire and
by unplugging the cable. Rimage
rmation or to order a new power cord, contact
0-2483.5 MHz
ul to the eyes. Do
not
procedures.
le.
110875_B

Publicité

loading