Publicité
Change the retransfer ribbon
Use this procedure to change the retransfer ribbon.
1.
Power off the printer.
2.
Remove the retransfer ribbon.
a.
Press the two side cover latches to
release the side cover.
b.
Lower the side cover.
c.
Open latches 1, 2, and 3.
d.
Pull out the retransfer ribbon carrier.
Note: The retransfer ribbon carrier
cannot be removed from the printer.
e.
To remove the retransfer ribbon from the
carrier, lift the retransfer rolls up and
carefully slide the retransfer ribbon from
the retransfer ribbon carrier.
3.
Discard the used retransfer ribbon.
4.
Install the new retransfer ribbon.
a.
Remove the retransfer ribbon from the packaging.
b.
With the supply roll on the left side, slide both
retransfer rolls under the retransfer ribbon carrier.
c.
Install the supply roll on the left side of the carrier
and snap the roll into place.
d.
Bring the take up roll up and around the guide rollers
and snap the roll into place.
e.
Ensure that the retransfer ribbon is aligned and straight across all
of the ribbon guides.
f.
To take up the ribbon slack, turn the take up roll counterclockwise
5.
Reassemble the printer.
a.
Slide the retransfer ribbon carrier into the printer.
b.
Close latches 1, 2, and 3.
c.
Close the side cover.
6.
Power on the printer. The printer is ready for use.
110875_B
All manuals and user guides at all-guides.com
Maintain the Everest printer
Side cover latches
Retransfer ribbon carrier
Supply roll
Side cover
Latch 2
Latch 3
Take up roll
19
Publicité
