Publicité
Everest III User Guide
Cleaning the Everest printer
A cleaning kit is provided with each Everest printer. Use this kit to clean your Everest printer as described in this
section.
Clean the print head with the Everest cleaning kit
1.
Power off the printer.
2.
Access the print head.
a.
Press the two cover latches to release the side cover.
b.
Lower the side cover.
c.
Open latch 1.
d.
Remove the print ribbon carrier. For specific instructions, refer to Changing the print ribbon on
page 17.
3.
Clean the print head.
Caution! Wipe the print head from one
end to the other. Do not stop wiping in
the middle of the print head.
Caution! Do not scratch the print head.
The white area
in the picture shows the
area to clean.
a.
Apply is
opropyl alcohol to the sponge
swab.
b.
Use the sponge swab to wipe across t
print head from one end to the other.
c.
Repeat as needed until the print head is clean of dust and debris.
d.
Use the sponge swab to remove any waxy buildup from the roller below the print head.
4.
Prepare the printer for use.
a.
Install the print ribbon carrier.
b.
Close all latches.
c.
Close the side cover.
5.
Power on the printer. The printer is ready for use.
20
All manuals and user guides at all-guides.com
Latch 1
he
Print head
Wipe
direction
110875_B
Publicité
