NOMA 052-4744-2 Guide D'utilisation page 7

ASSEMBLY
· Pull the black and white wires of receiver through
the centre hole of mounting bracket, then
continue the wire connections to outlet box
(see Fig. 7).
Connect the black live wire marked "AC IN L" from the receiver
to the live wire (typically black) from the outlet box. Connect
the white neutral wire marked "AC IN N " from the receiver to
the neutral wire (typically white) from the outlet box. Connect
the green ground wires from the mounting bracket and nylon
ball to the ground wire (bare or green) from the outlet box.
· Make sure your outlet box is grounded. Connect the ground wire (green or bare copper)
to the motor support bar ground wire. Secure the wire connection with a wire
connector provided (see Fig. 6).
· After the splices are made, secure connectors with electrical tape. Spread the wires apart so that the
green and white wires are on one side of the outlet box and the black and blue wires are on the other.
Make sure there are no loose strands or connetions. Turn wire connectors upward and push the
wiring into the outlet box.
Note:
The silver cord is only a safety support cable to prevent the fan from falling.
Secure the steel cable to the ceiling joist with the short wood screw and flat washer
provided.
WARNING!
green and white connections on opposite side of box from the black and blue (if applicable)
connections.
3. Motor assembly
· Remove the mounting screws and washers from
the mounting bracket (see Fig. 8).
· Remove the mounting screws and washers from the
motor support bar (see Fig. 8).
· Lift motor support bar to mounting bracket.
Turn motor so "T" bar end fits through rectangular
opening on mounting bracket. Align holes and secure
with washers and screws (see Fig. 9).
All manuals and user guides at all-guides.com
6
Be sure no bare wire or wire strands are visible after making connections. Place
8
Mounting bracket
Mounting
screws
9
Mounting screws
5
7
Motor suport bar
Mounting bracket
Motor suport bar