Pioneer VSX-1025 Mode D'emploi page 71

Using other functions
Setting What it does
c Adjusts the amount of treble.
TREBLE
S.RTRV With the Sound Retriever function, DSP processing is used to
(Sound Retriever) compensate for the loss of audio data upon compression,
improving the sound's sense of density and modulation.
DNR May improve the quality of sound in a noisy source (for example,
(Digital Noise video tape with lots of background noise) when switched on.
Reduction)
DIALOG E Localizes dialog in the center channel to make it stand out from
(Dialog other background sounds in a TV or movie soundtrack. By moving
Enhancement) from UP1 through UP2 and UP3 up to UP4, you can make the
sound source seem to relocate upwards.
DUAL Specifies how dual mono encoded Dolby Digital soundtracks
(Dual Mono) should be played. Dual mono is not widely used, but is sometimes
necessary when two languages need to be sent to separate
channels.
DRC Adjusts the level of dynamic range for movie soundtracks
(Dynamic Range optimized for Dolby Digital, DTS, Dolby Digital Plus, Dolby
Control) TrueHD, DTS-HD and DTS-HD Master Audio (you may need to use
this feature when listening to surround sound at low volumes).
LFE
Some audio sources include ultra-low bass tones. Set the LFE
(LFE Attenuate) attenuator as necessary to prevent the ultra-low bass tones from
distorting the sound from the speakers.
The LFE is not limited when set to 0 dB, which is the
recommended value. When set to –5 dB, –10 dB, –15 dB or –20
dB, the LFE is limited by the respective degree. When OFF is
selected, no sound is output from the LFE channel.
Brings out detail in SACDs by maximizing the dynamic range
g
SACD GAIN
(during digital processing).
h Specifies the routing of the HDMI audio signal out of this receiver
HDMI
(amp) or through to a TV. When THROUGH is selected, no sound
(HDMI Audio)
is output from this receiver.
A. DELAY This feature automatically corrects the audio-to-video delay
(Auto delay) between components connected with an HDMI cable. The audio
delay time is set depending on the operational status of the
display connected with an HDMI cable. The video delay time is
automatically adjusted according to the audio delay time.
Option(s)
–6 to +6 (dB)
Default: 0 (dB)
d
OFF
ON
OFF
ON
OFF
FLAT
UP1/UP2/UP3/UP4
CH1 – Channel 1 is
heard only
CH2 – Channel 2 is
heard only
CH1 CH2 – Both
channels heard from
front speakers
f
AUTO
MAX
MID
OFF
0dB/ –5dB/ –10dB/
–15dB/ –20dB
OFF
0 (dB)
+6 (dB)
AMP
THROUGH
OFF
ON
i
08
e
71
En