Pioneer VSX-1025 Mode D'emploi page 42

04 Basic Setup
4 Press
RECEIVER
5 Follow the instructions on-screen.
Make sure the microphone is connected, and if
you're using a subwoofer, make sure it is
switched on and set to a comfortable volume
level.
6 Wait for the test tones to finish, then
confirm the speaker configuration in the GUI
screen.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it's doing this.
If no operations are performed for 10 seconds
while the speaker configuration check screen
is being displayed, the Auto MCACC Setup will
resume automatically. In this case, you don't
need to select 'OK' and press ENTER in step 7.
• With error messages (such as Too much
ambient noise! or Check microphone.)
select RETRY after checking for ambient
noise (see Problems when using the Auto
MCACC Setup on page 43) and verifying the
mic connection. If there doesn't seem to be
a problem, you can simply select GO NEXT
and continue.
1a.Full Auto MCACC
Now Analyzing...
Environment Check
Ambient Noise
Microphone
Speaker YES/NO
L
FHL
Exit
C
FHR
R
SR
SBR
SBL
SL
SW
10
Exit
Note
1 Do not adjust the volume during the test tones. This may result in incorrect speaker settings.
2 If the speaker is not pointed to the microphone (listening position) or when using speakers that affect the phase
(dipole speakers, reflective speakers, etc.), Reverse Phase may be displayed even if the speakers are properly
connected.
3 You can also choose to view the settings from the MCACC Data Check screen. See Checking MCACC Data on page 98
for more on this.
42
En
and then select START.
1
A/V RECEIVER
2/9
: OK
:
:
1a.Full Auto MCACC
A/V RECEIVER
: YES
: YES
Cancel
: YES
: YES
: YES
: YES
: YES
: YES
: YES
: YES
OK RETRY
Cancel
The configuration shown on-screen should
reflect the actual speakers you have.
• If you see an ERR message (or the speaker
configuration displayed isn't correct), there
may be a problem with the speaker
connection.
If selecting RETRY doesn't work, turn off
the power and check the speaker
connections. If there doesn't seem to be a
problem, you can simply use / to select
the speaker and / to change the
setting and continue.
• If Reverse Phase is displayed, the
speaker's wiring (+ and –) may be inverted.
Check the speaker connections.
–
If the connections were wrong, turn off
the power, disconnect the power cord, then
reconnect properly. After this, perform the
Full Auto MCACC procedure again.
– If the connections were right, select GO
NEXT and
continue.
7 Make sure 'OK' is selected, then press
ENTER.
A progress report is displayed on-screen while
the receiver outputs more test tones to
determine the optimum receiver settings for
Channel Level, Speaker Distance, Standing
Wave and Acoustic Cal EQ.
Again, try to be as quiet as possible while this
is happening. It may take 3 to 10 minutes.
8 The Auto MCACC Setup procedure is
completed and the Home Menu menu
reappears automatically.
Be sure to disconnect the microphone from
this receiver upon completion of the Auto
MCACC Setup.
2
3