Pioneer VSX-1025 Mode D'emploi page 41

Basic Setup
1 Switch on the receiver and your TV.
2 Connect the microphone to the MCACC
SETUP MIC jack on the front panel.
Make sure there are no obstacles between the
speakers and the microphone.
CONTROL ON / OFF
iPod
iPhone
MCACC USB
SETUP MIC
If you have a tripod, use it to place the
microphone so that it's about ear level at your
normal listening position. If you do not have a
tripod, use some other object to install the
1
microphone.
Note
1 Install the microphone on a stable floor. Placing the microphone on any of the following surfaces may make accurate
measurement impossible:
• Sofas or other soft surfaces.
• High places such as tabletops and sofa tops.
2 If you leave the GUI screen for over five minutes, the screen saver will appear.
3 • When data measurement is taken, the reverb characteristics data (both before- and after-calibration) that this
receiver had been storing will be overwritten. If you want to save the reverb characteristics data before measuring,
connect a USB memory device to this receiver and transfer the data.
• When measurement is taken of data other than SYMMETRY, the data are not measured after the correction. If you
will need to measure after correction data, take the measurement using the EQ Professional menu in the Manual
MCACC setup (page 95).
4 If you are planning on bi-amping your front speakers, or setting up a separate speaker system in another room, read
through Speaker system setting on page 103 and make sure to connect your speakers as necessary before continuing
to step 4.
MASTER
VOLUME
VIDEO CAMERA
HDMI 5
Microphone
Tripod
The Full Auto MCACC display appears once
the microphone is connected.
1a.Full Auto MCACC
A/V RECEIVER
: Normal ( SB/FH )
Speaker System
EQ Type : SYMMETRY
MCACC : M1.MEMORY 1
THX Speaker :
Exit
3 Select the parameters you want to set.
If the speakers are connected using any setup
other than the Front height setup, be sure to
set the Speaker System before the Auto
MCACC Setup. See Speaker system setting on
page 103.
4
• Speaker System
system setting.
• EQ Type – This determines how the
frequency balance is adjusted.
• MCACC – The six MCACC presets are
used for storing surround sound settings
for different listening positions. Simply
choose an unused preset for now (you can
rename it later in Data Management on
page 100).
• THX Speaker – Select YES if you are using
THX speakers (set all speakers to SMALL),
otherwise leave it set to NO.
2
NO
START
Return
3
– Select your speaker
04
41
En