Publicité
Les langues disponibles
Les langues disponibles
1
Round sealing edge
7
2
12
28
13
29
42
42
27
86452440 Manual Ranger 12 120V 60Hz
If not already installed in the power head, first insert
bottom side of 86455330 (75146) sealing adapter
(28) into power head as shown.
Place the filter compartment (1) on the power head
(2) so that the connecting piece (13) reaches into the
corresponding opening while inserting round sealing
edge of sealing adapter into the air channel of filter
compartment (1).
Open the zipper (11) of the filter compartment by
moving the two sliders (12) all the way down to the
right and to the left. Make sure that both ends of the
zipper reach straight into the plastic part. They may
not be folded or protrude. Then press the bottom plate
of the filter housing with the flat of your hand and
shake it lightly or move the pre-installed handle to
simplify assembling.
For the final connection of the main assemblies, one
of the M5x30 screws (7) from the screw bag (6) is
used. It should now be easy to push it a few millime-
ters into the hole and then engage with the thread
inserted from the back.
Plug-in power cable plug (9) into mains connector
(27). Route cable as shown from bottom to top using
fixing points (42). All remaining cable length will then
move to the top automatically.
Close flap (29) of cable inlet.
When not in use, cable can be rolled up between the
rotating cable hook (18) and the grip.
Filter compartment, front view.
Cover not shown.
Operation
9
Publicité
