Rodania VALJOUX 7750 Mode D'emploi page 42

Winding
Crown in position I, not pulled out
Manual winding is necessary if you have not been wearing your watch for a considerable period of time. To restart it, you
only need to turn the crown a few times (clockwise), or tilt your watch from side to side a few times. To restore the power
reserve of your watch to more than 42 hours, you need to turn the crown 20 to 25 times (clockwise).
Whenever you wear your watch, the automatic mechanism is wound every time you move your wrist.
Setting the time
Pull the crown into position III; the small second hand (3) stops at this point. Turn the crown clockwise or anticlockwise
until your watch displays the correct time. Whenever the hour hand passes the 12-o'clock position, you will see whether
it is displaying midnight (the date changes) or midday (the date does not change).
Setting the day* and date*
Important: Do not set the date* and/or the day* between 10 pm and 2 am (the movement is in the process of changing
the date). This will seriously damage the movement, and such damage is not covered under the Rodania warranty. Pull the
crown into position II and turn it clockwise to adjust the date (4), turn it counterclockwise to change the day (5)*. During
this operation, your watch continues to function normally so there is no need to correct the time afterwards.
* Depending on model
Chronograph function
Press the Stop/Start push button (10) to start the timing operation. Press it again to stop. The timing restarts when you
press the Stop/Start push button (10) again. Reset to zero by pressing the push button (11).
Tachometer (depending on model)
The speedometer is used to measure the speed of an object. The maximum period to be measured is 60 seconds. Start
the timing operation and stop it again once you have covered a distance of 1 km. The chronograph hand then points at a
numeral on the tachometric scale (9), indicating the speed in km/h.
42 l www.rodania.com