Publicité
plus probable que vous reconfiguriez ce jeu de ports à l'aide d'adresses IP statiques, mais
ce scénario vous présente un exemple de configuration de post-installation. Reportez-vous à
la section
Modification de la configuration réseau (page 50)
pour plus d'informations.
# net set wizard
StoreOnce Network Configuration Wizard
--------------------------------------
This Wizard will guide you through the configuration of
network settings on your StoreOnce Backup System.
If you wish to make additions or modifications to an existing
network configuration without having to reconfigure all settings,
use the 'net modify' or 'net add' commands instead.
See the User Guide guide for physical port layout details.
The wizard consists of the following steps:
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
Step 2) Configure network settings for available network adapters
Step 3) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard.
Step 1) Set system wide DNS server addresses (optional) and cluster size (if multi-node)
----------------------------------------------------------------------------------------
Enter a list (max 3) of DNS servers separated by commas; this list may be blank.
The IP version used here must match that used on the management interface later on.
For example, for IPv4: 192.168.1.100,192.168.3.100
For example, for IPv6: 2001:DB8::0,2001:DB8::1
-->172.1.1.100,172.1.2.100,2001:DB8::1
<--DNS servers: 172.1.1.100,172.1.2.100,2001:DB8::1
*Step Complete* Do you want to :
1 = Go to next step: Step 2) (default)
2 = Go back to start of present step: Step 1)
3 = Quit wizard and lose all settings
-->1
<--Navigation: Go to next step: Step 2)
Step 2) Configure network settings for available network adapters
-----------------------------------------------------------------
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "Port Set" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->1
<--Bonded/Single: Single port
Select network adapter :
1 = eth0 (1 Gig) (default)
2 = eth1 (1 Gig)
3 = eth2 (1 Gig)
4 = eth3 (1 Gig)
5 = eth4 (10 Gig)
6 = eth5 (10 Gig)
-->1
<--Single Port: eth0 (1 Gig)
Is this subnet on a Virtual LAN?
1 = No (default)
2 = Yes
-->1
<--VLAN/Not VLAN: No
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
Do you want to configure a static default gateway for this subnet or get the gateway information from
DHCP?
--------------------------------------------------------
Note for ipv6 DHCP servers a static gateway is required.
--------------------------------------------------------
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually (this may be blank if no gateway is required)
-->1
44
Configuration réseau, comment utiliser les commandes CLI de StoreOnce
Publicité
