Husqvarna 553RBX Manuel D'utilisation page 24

a) Shake or pull the drive shaft out of the drive shaft
sleeve.
2. Lubricate the drive shaft.
3. Push and turn the drive shaft at the same time to put
it back in the drive shaft sleeve. Keep approximately
10 mm / 0.40 in. of the drive shaft outside the edge
of the drive shaft sleeve.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
24
4. Align the hole in the drive shaft sleeve with the knob
5. Push and turn the drive shaft at the same time to
Troubleshooting
Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Incorrect fuel type.
on the clutch cover.
connect it.
Procedure
Let an approved service agent re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. See
uct overview on page 2 .
Let an approved service agent help
you.
Drain the fuel tank and fill with cor-
rect fuel.
Prod-
1104 - 010 - 12.06.2023