Grundig GKNI56930FN Manuel D'utilisation page 7

• Do not block or cover ventilation
holes. Otherwise, power
consumption may be increased and
damage to your product may occur.
• Do not connect the product to
supply systems such as solar
power supplies. Otherwise,
damage to your product may occur
as a result of the abrupt voltage
fluctuations!
• The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m³ of
volume is required for each 8
grams of refrigerant. The amount
of the refrigerant available in your
product is specified in the Type
Label.
• The installation place of the
product shall not be exposed to
direct sunlight and it shall not be in
the vicinity of a heat source such as
stoves, radiators, etc.
If you cannot prevent installation of
the product in the vicinity of a heat so-
urce, you shall use a suitable insulati-
on plate and the minimum distance to
the heat source shall be as specified
below.
- At least 30 cm away from heat
sources such as stoves, heating units
and heaters, etc.,
- And at least 5 cm away from
electric ovens.
• Your product has the protection
class of I. Plug the product in a
grounded socket that conforms
with the Voltage, Current and
Frequency values specified in the
type label. The socket outlet shall
be equipped with a fuse with a
rating of 10 A – 16 A. Our company
shall not be responsible for the
damages that shall be incurred as
a result of operating the product
without ensuring ground and
electrical connections made as
per local or national regulations.
• The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock
and injury may occur!
• Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their
seats or sockets with a risk of
water contact.
• Place the power cord and hoses
(if available) of the product so
that they shall not cause a risk of
tripping over.
• Penetration of humidity to live
parts or to the power cord may
cause short circuit. Thus, do
not use the product in humid
environments or in areas
where water may splash (e.g.
garage, laundry room, etc.)
If the refrigerator is wet by
water, unplug it and contact an
authorized service.
• Do not connect your refrigerator
to power saving devices. These
systems are harmful for the
product.
A
1.6 Operational safety
• Do not use chemical solvents
on the product. These materials
contain an explosion risk.
• In case of a failure of the product,
unplug it and do not operate until
it is repaired by the authorized
service. There is a risk of electric
shock!
IT
PL
7