Grundig GKNI56930FN Manuel D'utilisation page 13

4.3 Disposing of the packaging
The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions stated by your
local authorities. Do not throw away
with regular house waste, throw
away on packaging pick up spots
designated by the local authorities.
The packing of your refrigerator is
produced from recyclable materials.
4.4 Disposing of your
old refrigerator
Dispose of your old refrigerator
without giving any harm to the
environment.
• You may consult your authorized
dealer or waste collection center
of your municipality about the
disposal of your refrigerator.
Before disposing of your refrigerator,
cut off the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.
4.5 Placing and Installation
A
If the entrance door of the
room where the refrigerator will be
installed is not wide enough for the
refrigerator to pass through, then
carefully remove the doors of your
refrigerator and pass it sideways
through the door.
1. Install your refrigerator to a place
that allows ease of use.
2. Keep your refrigerator away from
heat sources, humid places and
direct sunlight.
3. There must be appropriate air
ventilation around your refrigerator
in order to achieve an efficient
operation. If the refrigerator is to be
placed in a recess in the wall, there
must be at least 5 cm distance with
the ceiling and at least 5 cm with the
wall. Do not place your product on
the materials such as rug or carpet.
4. Place your refrigerator on an even
floor surface to prevent jolts.
5. This product cannot be used in
rooms where the temperature drops
below 5°C.
6. Your product requires adequate air
circulation to function efficiently.
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between the
product and the ceiling, rear wall
and the side walls.If the product will
be placed in an alcove, remember
to leave at least 5 cm clearance
between the product and the ceiling,
rear wall and the side walls. Check
if the rear wall clearance protection
component is present at its location
(if provided with the product). If the
component is not available, or if it
is lost or fallen, position the product
so that at least 5 cm clearance shall
be left between the rear surface
of the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.
WARNING:
Do not locate extension
sockets or charging
transformers/power supplies or
Lithium-Iron battery operated
products adjacent to the compressor
as they could overheat.
IT
PL
13