KRESS KG161 Serie Mode D'emploi page 11

Cutting Tips
1. Move the trimmer from left to right across the
area to be cut; it is less effective when moving
from right to left.
2. Use the tip of the cutting line to do trimming; do
not force the trimmer head into uncut grass.
3. Wire and picket fences may cause extra cutting
line wear and breakage. Stone and brick walls,
curbs, and wood may wear cutting line rapidly.
4. Avoid trees and shrubs. Tree bark, wood
moldings, siding, and fence posts can easily be
damaged by the cutting line.
MAINTENANCE
WARNING! Always remove the battery
pack from your trimmer after use.
Always check the product prior to being used for
any damage.
Replacing the trimmer head (See Fig. I)
Warning:Use of wire or metal-reinforced
line is not authorized and could be
extremely dangerous. Use only the cutting line
recommended in this manual, in combination
with the recommended debris guard.
I
Warning:A damaged or loose cutting
attachment head may vibrate, crack, break
or come off the trimmer, which may result in
serious or fatal injury or property damage. Make
sure the trimmer head are properly and securely
tightened and in good condition before starting
work.
1. Insert the hex key into the hole and rotate the
trimmer head until it stops in a locked position.
2. Then, rotate clockwise to remove it, and
counterclockwise to assemble it.
Winding the line (See Fig. J1, J2)
J1
J1
J2
J2
2m
2m
2m
2m
1. Insert the replacement line (13 ft or 4 meters)
through the eyelet and feed it through the other
side.
K1
2. Ensure both ends of the line extending out of the
K1
trimmer head are the same length. Approximately
6ft or 2 meters on each side of the trimmer head,
cut lengths even if necessary.
3. Turn the dial clockwise to wind the line inside the
spool until about 19cm remains on either side.
K2
K2
EN
11