Maintenance Chart - DeWalt DG3000 Guide D'utilisation

notE: Take note of the positions and locations of parts during
disassembly to make reassembly easier.
notE: Any service operations not included in this section should be
performed by a D WALT factory service center or a D
e
service center.
The following procedures must be followed when maintenance or ser-
vice is performed on the generator.

Maintenance Chart

procedure
Test GFCI X
Clean generator's exterior
Clean battery pack and
charger
Check oil level+ X
Change oil *+
Clean air filter +
Clean spark plugs+
Check fuel line, hose clamps
X
and fuel tank
Oil leak inspection X
Spark arrestor
Sediment cup
Clean fuel tank and filter
WALT authorized
e
X
X
X(1)
X(1)
X
X
X
X(2)
24
Check for unusual
X
noise/vibration
Prepare unit for storage if it is to remain
Prepare unit for Storage
idle for more then 30 days
* The engine oil must be changed after the first 20 hours or operation.
Thereafter change oil every 150 hours of operation or monthly, whichever
comes first.
+ See engine's instruction manual for correct procedure.
(1) Perform more frequently in dusty or humid conditions
Should be performed by a D
(2)
e
D WALT authorized service center.
e
Generator
tESt GfCI
1. Start the generator. IMportant: Engine must be running to test
GFCI.
2. Place the auto control idle switch (Y) in the OFF
position.
3. Push in the TEST button A on the receptacle. The
RESET button B will pop out. Power is now off at
the receptacle. If the RESET button does not pop
out, contact a D WALT factory service center or
e
a D WALT authorized service center. Do not run
e
generator until the problem can be corrected.
4. To restore power to receptacle, push the RESET
button in. If the RESET button pops out during operation, stop the
generator and check the generator and equipment for defects.
Contact a D WALT factory service center or a D
e
service center.
WALT factory service center or a
B A
WALT authorized
e