Transportation, Storage And Disposal - Husqvarna K 7000 Manuel D'utilisation

Problem
The vibration levels
are too high.
The product cuts too
slowly.
The diamond chain
becomes longer
when you use it.
The temperature of
the product is too
high.
The diamond chain
breaks or derails.
Transportation and storage
• Safety the product during transportation to prevent
damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in dry, frost free conditions.
• Examine the product for transport and storage
damage.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
22
Causes
The diamond chain is not installed correctly.
The diamond chain is defective.
The vibration damping units are defective.
The diamond chain is not sharp.
The operator does not apply sufficient pres-
sure to the product during operation.
Too low water pressure.
Incorrect diamond chain tension.
You cut into a slot that is smaller than the di-
amond chain segments.
The operator does not apply sufficient pres-
sure to the product during operation.

Transportation, storage and disposal

Solution
Make sure that the diamond chain and the
guide bar are correctly installed. Make sure
that the diamond chain and the guide bar are
not damaged.
Replace the diamond chain.
Speak to an approved service agent.
Cut into soft material, such as sandstone or
brick.
Apply more pressure to the product during
operation.
Increase the water pressure.
Adjust the diamond chain tension.
Use correct working techniques. Refer to
sic working techniques on page 13 .
Apply more pressure to the product during
operation.
service or the shop from where you purchased the
product.
Ba-
1455 - 003 - 03.03.2020