Functional Description - Makita CL183D Manuel D'instruction

Avoid storing battery cartridge
(2)
in a container with other metal
objects such as nails, coins, etc.
Do not expose battery cartridge
(3)
to water or rain.
A battery short can cause a large
current flow, overheating, possible
burns and even a breakdown.
Do not store the tool and battery
6.
cartridge in locations where the
temperature may reach or exceed
50°C (122°F).
Do not incinerate the battery car-
7.
tridge even if it is severely damaged
or is completely worn out. The bat-
tery cartridge can explode in a fire.
Be careful not to drop or strike
8.
battery.
Do not use a damaged battery.
9.
Follow your local regulations relat-
10.
ing to disposal of battery.
SAVE THESE
INSTRUCTIONS.
Tips for maintaining maximum
battery life
Charge the battery cartridge before
1.
completely discharged.
Always stop tool operation and
charge the battery cartridge when
you notice less tool power.
Never recharge a fully charged bat-
2.
tery cartridge.
Overcharging shortens the battery
service life.
Charge the battery cartridge with
3.
room temperature at 10°C - 40°C
(50°F - 104°F). Let a hot battery car-
tridge cool down before charging it.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before adjust-
ing or checking function on the tool.
• Take care not to trap finger(s) between cleaner
and battery as shown in diagram when loading
battery.Trapping finger(s) may cause injury.
Installing or removing battery
cartridge
3
► 1. Red indicator 2. Button 3. Battery cartridge
CAUTION:
• Always switch off the tool before installing or
removing of the battery cartridge.
• Hold the tool and the battery cartridge firmly
when installing or removing battery car-
tridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your
hands and result in damage to the tool and
battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge align the tongue on the
battery cartridge with the groove in the housing and slip
it into the place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
4 ENGLISH
1
2