Installation Maunal; Installation Guide; Installation Of Accessories; Position For Indoor Unit - GIA Pure Light UV HTWS026PLUV Manuel D'installation

INSTALLATION MANUAL

Installation Guide

This air conditioner meets the safety and operation standards promulgated by the Na-
•
tion.
You need to invite professional air conditioner service and maintenance personnel to
•
install or remove the air conditioner. Problems may occur and you may suffer losses if
non- professionals install the air conditioner.
User shall provide the power that meets installation and operation requirements. plea-
•
se refer to nameplate for details about the voltage for this product. Voltage beyond this
scope will affect the normal operation of the air conditioner.
Separate power point with delay fuse protector or automatic breaker should be used for
•
the air conditioner.
The air conditioner must be correctly and reliably grounded, or it may cause electric
•
shock or fire.
Do not switch on the power of the air conditioner before well connecting and carefully
•
checking the tubing and wires.
The appliance shall not be installed in laundry or bathroom.
•
In case necessary, please consult your supply authority for system information.
•
The plug shall be accessible after installed the appliance.
•
This instruction is subject to change without notice.
•

Installation of Accessories

Examine carefully the attached packing list and check whether the accessories are
•
complete.
Users may need to buy at their own expenses the articles not included in the packing
•
list and may be needed in installing.

Position for Indoor Unit

Away from the place where there is heat source, steam source, leakage of flammable
•
gas and smoke.
No obstacles near the inlet and outlet, and keep good ventilation.
•
Good discharge for water.
•
At least 1m away from wireless equipment
•
(such as TV, radio etc.).
Mounted on the wall that can bear the weight
•
of the air conditioner and won't produce noise
while unit working.
The distance between the indoor unit and the
•
floor should be greater than 2.3m.
The plug shall be accessible after installing the
•
appliance.
Ensure the distance as required in Fig.1.
•
The back of the indoor unit should be close to
•
the wall(Fig.1)
At least 15cm
25