Husqvarna 435e II Manuel D'utilisation page 7

Symbols on the machine:
WARNING! Chainsaws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chainsaw.
Never operate a chainsaw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
Recommended cutting
equipment in this
example: - Bar length 15
inches - Max. nose radius
10Teeth - Chain type Husqvarna H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Running H/F 2 Rev. 3 2018-12-03
KEY TO SYMBOLS
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Refuelling.
Chain oil fill.
Air purge
Adjustment of the oil pump
Chain brake, activated (right) Chain
brake, not activated (left)
The rating plate
showing serial
number. yyyy is
the production
year, ww is the
productionweek.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
XX
XX
yyyywwxxxxx
English
–
7