BaBylissPro 4rtists FX8705E Mode D'emploi page 10

CLIPPER
Taper Control
The taper control lever enables
fine cut adjustment for precision
clipping.
• To increase the cutting length,
push the lever down.
• To reduce the cutting length, push
the lever up.
Comb Guides:
This appliance is supplied with 8
comb guides:
1.5mm (1/16")
3mm (1/8'')
4.8mm (3/16")
6mm (1/4'')
10mm (3/8'')
13mm (1/2'')
16mm (5/8'')
19mm (3/4'')
• To attach a comb guide, ensure
the appliance is switched off.
Position the comb guide over
the front of the clipper blade and
slide over the head. Push and click
the rear of the comb guide into
position.
• To remove the comb guide,
ensure the appliance is switched
off. Push the tab on the rear of the
comb guide away from the head
and lift off.
#.5
TRIMMER
#1
Comb guides
#1.5
This trimmer is supplied with 2
comb guides.
#2
#3
No.1 - 6mm
No.2 - 10mm
#4
#5
To attach a comb, hold it by the
sides and clip it over the teeth of
#6
the blade.
To remove the comb, simply push
off.
Zero gap adjustment tool
IMPORTANT! Only ever attempt
to zero gap the blades using the
adjustment tool, following the
instructions very precisely.
The adjustment tool is required to
adjust the blades to zero gap, to
achieve a closer, more precise cut.
10