Publicité
1. Oil filter cover
2. Oil filter
3. O-ring
1. Couvercle du filtre à huile
2. Filtre à huile
3. Joint torique
1. Tapa del filtro de aceite
2. Filtro de aceite
3. Junta tórica
5. Remove the oil filter cover and oil filter.
6. Clean the oil strainer and oil filter with solvent.
7. Inspect the O-ring and replace if damaged.
8. Install the oil filter, O-ring, and oil filter cover.
9. Replace the oil strainer, compression spring,
O-ring and drain bolt. Then, tighten the drain
bolt and oil filter cover bolts to the specified
torques.
CAUTION:
_
Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer.
_
Tightening torque:
Drain bolt (engine):
43 Nm (4.3 m·kgf)
Oil filter cover bolt:
10 Nm (1.0 m·kgf)
10. Fill the engine with oil and install the dipstick.
8-17
Publicité
