Bosch DWK65AJ 0R Serie Manuel D'utilisation Et Notice D'installation page 8

en Troubleshooting
Observe the information regarding the cleaning
1.
agents.
Place the grease filters loosely into the dishwasher.
2.
Do not clean heavily soiled grease filters with
utensils.
Use special grease solvent for stubborn dirt. You
can obtain grease solvents from after-sales service
or the online shop.
Start the dishwasher.
3.
Select a temperature of no more than 70 °C.
4. Allow the grease filters to drain.
8.7 Fitting grease filters
ATTENTION!
Falling grease filters may damage the hob below.
Grip below the grease filter with one hand.
▶
1. Fit the grease filters.
Fold the grease filters upwards and engage the
2.
locks.
Make sure that the locks engage.
3.
Close the filter cover.
4.
8.8 Odour filter for recirculating air mode
Odour filters bind odorous substances in air recircula-
tion mode. Regularly replaced odour filters guarantee a
high level of odour removal.
With normal use (approx. one hour a day), the odour fil-
ter must be replaced every 3-5 months. The odour fil-
ter cannot be cleaned or regenerated.
You can obtain odour filters from the after-sales service
or the online shop. Only use original odour filters.
→ "Accessories", Page 6
9 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
9.1 Malfunctions
Fault
The appliance is not
working.
The LED lighting
does not work.
8
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
The LED lamp is defective.
→ "Replacing the LED lights", Page 9
▶
Removing odour filter
Requirement: The grease filters have been removed.
Rotate the old odour filters ​ ⁠ and remove them
▶
from the holder ​ ⁠ .
2
1
Fitting odour filters
Push the new odour filters onto the holder ​ ⁠ and
1.
rotate ​ ⁠ .
1
2
Install the grease filters.
2.
→ "Fitting grease filters", Page 8
2
1
1
2