Copy Time Control - Yamaha CRX-E300 Mode D'emploi

Copy time control

By specifying the length of the tape, CRX-E300 programs
tracks or helps you to program tracks so they will fit onto
the tape with the least amount of unrecorded space
remaining at each end of the tape.
1 Manual tape programming
POWER
1
1
4
4
7
7
0
FREQ/RDS MODE – PTY SEEK – START
REP
REP
A
TEXT/TIME
D
DIRECTION
PRESET TUNER
MD
CD
MD
REC/PAUSE
DUBBING
MODE
MODE
SLEEP
VOLUME
1
Insert the desired disc into the CD player, and load a
blank tape into the KX-E300.
2
Press CD.
3
Press R.TIME repeatedly to select the length of tape
to be used. Each time you press R.TIME, the length
of the tape changes as follows:
46
90
• You can use numeric buttons to input the length of
the tape.
4
Press PROG to start programming.
• "A B" appears in the display to indicate the
direction of the tape.
2 3
2 3
5 6
5 6
8 9
8
+10 +100
RANDOM PROG
PROG
B C
R. TIME
R.TIME
E
TAPE
PRESET
CD TAPE
AUX
TAPE
REC/PAUSE
DUBBING START DUBBING
START
DISPLAY
54
60
SYSTEM CONTROL
5
Select the desired track number using numeric
buttons.
• Repeat step 5 to continue programming tracks.
• The remaining time is shown on the display. If the
track is longer than the remaining time, "TM
Over" appears on the display.
6
Press R.TIME to continue programming tracks on
side B.
• Repeat step 5.
7
Choose CD = TAPE by pressing DUBBING
MODE, and press DUBBING START to start
recording.
2 Automatic tape programming
1
Repeat steps 1 to 3 of "Manual tape programming".
2
Press REP to start programming.
• Programming is done in the order on the CD from
side A to side B. When complete, the following
display appears.
(Example) when 11 tracks have been programmed
You can change the program data following the steps
described on page 18, "To change program data".
3
Choose CD = TAPE by pressing DUBBING
MODE, and press DUBBING START to start
recording.
To stop dubbing
Press & on KX-E300.
To cancel tape programming
Press & on CRX-E300 when dubbing is stopped.
PROG B
23