Publicité
Les langues disponibles
Les langues disponibles
BM 2610027769 09-12_BM 2610027769 09-12.qxp 9/12/12 2:33 PM Page 10
FOOTPLATE ADjUSTMENT
The footplate tilts in order to keep as much of
its surface in contact with the work surface
(Fig. 4) . To adjust, hold saw firmly and pivot
footplate to desired position.
SAW HOOK
Your tool is equipped with a convenient saw
hook for hanging your tool. To use, simply lift
up hook until it snaps into the open position
(Fig. 5).
When using the saw hook
WARNING
always be aware that the
accessory is exposed. Always hang the tool
in an area where yourself and bystandards can
not accidently make contact with the
accessory.
To reduce the risk of injury, use care in
selecting the location for hanging the tool.
• Select a suitably sized and shaped object
that will provide adequate hanging stability.
An unstable hanging surface could result in
the tool unexpectedly falling.
• Insure that the tool is hung out of the way of
walkways and working areas with bystanders.
The tool could be bumped or a bystander
1. Securely clamp the work.
2. Mark the line of cut and grasp the tool with
one hand on the handle and the other
placed on the insulated rubber boot over
the front housing.
Always operate the saw
WARNING
with the insulated boot on
the front housing. If you saw into a blind area
where live wiring exists, you may be shocked
or electrocuted.
3. Keep the saw footplate firmly against the
work to minimize counter-force (jumping)
and vibration.
All manuals and user guides at all-guides.com
could become entangled causing the tool to
unexpectedly fall.
hook if it appears damaged or deformed.
This could result in unstable hanging and the
tool unexpectedly falling.
When not in use, always close hook until it
snaps into the closed position.
FIG. 5
Using the Saw
4. Squeeze the trigger to start the tool. Let the
Following a few simple tips will reduce the
wear on the workpiece, the tool and the
operator.
1. Blades cut on the draw or back stroke. On
2. Use the correct saw blade for the material
-10-
PIVOTING
FOOTPLATE
To reduce the risk of injury,
WARNING
Do not use the hanging
saw reach full speed before starting the cut.
Guide the saw so that the blade will move
along the marked line.
SAWING TIPS
fine work, such as paneling, fiberglass, etc.,
place the good side of workpiece facing
down.
being cut and keep extra blades on hand to
FIG. 4
SAW HOOK
Publicité
