Publicité
Les langues disponibles
Les langues disponibles
POWER CENTER INSTALLATION
1.
Remove the screw on each end of power center
and lift silver cover to open and expose four screw
holes. (See Figure 8)
Figure 8
2. Insert opened power center into hole in middle of
add-on top. (See Figure 9)
3. Use four screws included with power center to attach
power center to table. (See Figure 10)
Figure 10
NOTE: Screws above are included with power
center.
PAGE 4 OF 12
ASSEMBLY CONTINUED
Figure 9
Add-On Top
4. Replace silver cover and attach using two screws.
(See Figure 11)
NOTE: Use cable clips to organize wires under
the table. (See Figure 11)
Figure 11
Starter Top
Starter Top
1-800-295-5510
uline.com
Starter Top
Add-On Top
Starter Top
Add-On Top
Add-On Top
Cable Clip
Cable Clip
1022 IH-8234
Publicité
