Publicité
Les langues disponibles
Les langues disponibles
NOTE: If assembling a 192 x 48" table, add extra
add-on rails and center legs during this step.
(See Figure 5)
Figure 5
Add-On
Rail
End Rail
End Leg
2. Place starter top and add-on top over assembled
frame. Align holes on underside of starter tops and
add-on top(s) with the holes in the frame and attach
using M6 x 60 mm bolts. (See Figure 6)
Figure 6
Add-On Top
Starter Top
NOTE: Use M4 x 100 mm Allen wrench to fully
tighten all bolts.
NOTE: Quantity of bolts will differ based on how
many center legs are used.
PAGE 3 OF 12
ASSEMBLY CONTINUED
End Rail
End Leg
Center Leg
192 x 48" Table
Starter Top
M6 x 60 mm Bolt
3. Attach bracket to underside of tabletops near
outside of center legs using eight 4 x 25 mm screws.
Repeat for remaining sides of center legs.
(See Figure 7)
Figure 7
NOTE: Quantity of brackets will differ based on
how many center legs are used.
Completed Assembly
Add-On Top
Starter Top
Add-On Top
Starter Top
NOTE: For powered tables, proceed to page 4
for power center installation instructions.
260 x 100 x 3 mm
Bracket
4 x 25 mm
Screw
Starter Top
Starter Top
1022 IH-8234
Publicité
