Publicité
Les langues disponibles
Les langues disponibles
2. Place tabletops over assembled frame. Align holes
on underside of tabletops with holes in frame and
attach using 20 M6 x 60 mm bolts. (See Figure 2)
Figure 2
Starter Top or
Add-On Top
Starter Top
NOTE: Use M4 x 100 mm Allen wrench to fully
tighten all bolts.
3. Attach bracket to underside of tabletops near outside
of center leg using eight 4 x 25 mm screws. Repeat
on opposite side of center leg. (See Figure 3)
Figure 3
NOTE: For powered table, proceed to Power
Center Installation on page 4.
PAGE 2 OF 12
ASSEMBLY CONTINUED
M6 x 60 mm Bolt
4 x 25 mm
Screw
260 x 100 x 3 mm
Bracket
Completed Assembly
Starter Top
Starter Top
Add-On Top
Starter Top
120 x 48", 144 x 48" AND 192 x 48"
TABLES
1.
Position center legs between end legs. Align holes
in end rail with legs and attach using eight
M6 x 15 mm bolts. Repeat for remaining end rails
and add-on rails. (See Figures 4-5)
NOTE: Ensure holes for tabletops in end rails are
facing upwards.
NOTE: Do not fully tighten screws until tops are
attached to frame. (See Figure 6)
NOTE: If assembling a 120 x 48" table, add-on
rails will be slightly shorter than end rails.
Figure 4
M6 x 15 mm
Center Leg
End Rail
End Leg
Bolt
End Rail
Add-On
Rail
End Leg
Center Leg
144 x 48" Table
1022 IH-8234
Publicité
