Publicité
Les langues disponibles
Les langues disponibles
Final Luminaire Prep
The luminaire is shipped with a protective plastic insert
that is intended to stay in the luminaire during building
construction to keep dust and dirt from accumulating on
the luminaire. Once allbuilding construction and cleanup is
complete,the plastic insert is to be removed and recycled
(Figure 6.).
Figure 6. Removed Plastic Insert
MAINTENANCE
Fixture Maintenance/Cleaning
Always follow recommended cleaning and handling
procedures when cleaning the WaveStream lens. It can be
permanently damaged if cleaned or handled improperly.
Before cleaning a WaveStream lens, take time to inspect
the surfaces carefully in order to determine the type and
severity of the contaminants. The process of cleaning
the lens can result in damage to the optical surface if
repeated multiple times. For WaveStream lens with multiple
contaminants, the order with which they are removed
can be important. For instance, if a WaveStream lens is
contaminated with oil and dust, it is possible that wiping the
oil off first will scratch the optical surface as the dust is drug
along the surface by the wipe.
Blowing off the Surface of an Optic
Dust and other loose contaminants should be blown off
before any other cleaning technique is employed. Using
compressed air over the entire lens is recommended to
prevent static buildup.
When using compressed air, hold the can upright
throughout the procedure. Also, start the flow of air with
the nozzle pointed away from the lens. Hold the can
approximately 6" from the optic and use short bursts. Move
the nozzle of the compressed air can over the optic with the
nozzle at a grazing angle to the optical surface in a constant
one-way direction. Due to the non-contact and solvent-free
nature of this cleaning method, it should be used as a first
step in cleaning all optics.
Installation Instructions – Luminaire WaveStream
0590AWSIS
ADF140666
Installation Instructions – Luminaire WaveStream
Additional Cleaning Methods
Fingerprints and large dust particles can be removed by
gently wiping the surface with a clean microfiber cloth. If
additional cleaning is required a mild solution of distilled
water and Dawn® dish soap (between 1:20 and 1:10 parts
Dawn to distilled water, respectively) could be used to wash
the lens. The WaveStream lens should not remain wet any
longer than necessary to remove the contaminants. Dry off
surface with deionized air. Avoid pooling of water as that
tends to leave streaks on the optical surface. This method is
only recommended as a last resort as it increases the risk
of damaging the lens.
N
ote:
Avoid any organic solvents. In addition, avoid any
cleaning products including ammonia, ketones,
window cleaners, or other alcohol based cleaners
and solvents containing thinners, acetone, benzene
and tetrachloride.
N
ote:
For additional information on material compatibility in
regard to environmental contact with chemicals and
solvents please visit http://www.cooperindustries.
com/content/ public/en/lighting/products/indoor_ceil-
ing_wall_mount_lighting/ceiling_mount/_181854.
brands.lighting!metalux!options_accessories.html
www.eaton.com
3
Publicité
