Eaton Metalux Cooper Lighting I5-454HT5-UPL-L5-MS Instructions D'installation

ADF140670
Installation Instructions – Shielding Media
Instructions d'installation – Accessoire de protection
Instrucciones de instalación de los elementos de la pantalla
protectora
IMPORTANT: Read carefully before installing fixture. Retain
for future reference.
WARNING
Risk of fire, electrical shock, cuts and or other casualty
hazards. This product must be installed in accordance
with the applicable installation code by a qualified
electrician or a person familiar with the construction
and operation of the product and the hazards involved.
Cooper Lighting assumes no responsibility for claims
brought about by improper or careless installation or
handling of this product.
ATTENTION
Receiving Department: Note actual fixture description
of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly
with carrier. Claims for concealed damage must be
filed within 15 days of delivery. All damaged material,
complete with original packing must be retained.
CAUTION
Edges May Cut. Handle with care.
CAUTION
Risk of burn. Disconnect power and allow fixture to cool
before changing bulb or handling fixture.
INSTALLATION
Shielding Media Installation
1. Rotate all latches counter clockwise (Figure 1.).
2. Shielding media (baffle, lens or louver) will drop from
fixture and hang from safety cables.
3. To install, reverse steps 1 and 2
WARNING
Risk of Fire and Electric Shock. If not qualified, consult
an electrician.
NOTICE
Green ground screw provided in proper location. Do not
relocate.
NOTICE
If supply wires are located within 3 inches of ballast, use
wire rated for at least 90°C (194°F).
NOTICE
Lamps Contains Mercury, Dispose according to local,
state, or federal laws.
NOTICE
Minimum 90°C supply conductors.
Figure 1.
Brand Logo
reversed out of
black
INS # INS #
Clockwise to Latch
Counter Clockwise to
Unlatch