Publicité
Les langues disponibles
Les langues disponibles
2. Installation accessory
2. Prepare the following assemblies on the site.
No.
Name
1
Switch box
Wiring Tube (Insulating
2
Sleeve and Tightening
Screw)
Precaution of installing the wire controller
1. This manual provides the installation method of wired
controller. Please refer to the wiring diagram of this installation
manual to connect the wire controller with indoor unit.
2. The wired controller works in low voltage loop circuit. For to
directly contact the cable of high voltage above, like
115V,220V,380V, and don't wire this kind of wire in the said
loop; wiring clearance between configured tubes should be at
the range of 300~500 mm or above.
3. The shielded wire of the wired controller must be grounded
firmly.
4. Upon finish the wire controller connection, do not employed
tramegger to detect the insulation.
3
Speci cation
Qty.(embeded
(only for reference)
into wall)
1
1
Remarks
Publicité
