PACLITE Equipment M600NH Manuel De L'opérateur page 13

M600NH / M700 / M900 / M900-CC / M1200-CC
MAINTENANCE
The Paclite MASTER Trowel is designed to give many years of trouble free operation. It is, however, important that
the simple regular maintenance listed in this section is carried out. It is recommended that an approved Paclite
Equipment dealer carry out all major maintenance and repairs. Always use genuine Paclite replacement parts, the
use of spurious parts may void your warranty. Before any maintenance is carried out on the machine, switch off
the engine and disconnect the HT lead from the spark plug. Always set the machine on level ground to ensure
any fl uid levels will be correctly read. Only use recommended oils.
RUNNING IN PERIOD
When the trowel is fi rst used from new, the engine oil must be changed after the initial running in period. (see
engine manual for full details).
MACHINE CLEANING
Clean the machine after it has been used to prevent the collection of hardened cement. The blades can usually be
cleaned with a high-pressure hose and water while the concrete is still wet. Hard cement/concrete is very diffi cult
to remove. Immediately replace any labels/stickers should you notice that they are worn, missing, or damaged.
CHANGING BLADES
Be careful when changing old blades for new. Due to the way the blades wear, the old blades
become very sharp and can cut easily. Wear heavy duty gloves to avoid injury. BLADES MUST BE
REPLACED AS A SET!!!
CAUTION
Rountine maintenance
Check condition
Air Filter
Clean/Replace
Check level
Engine Oil
Change
Cutout Switch Check
Belt Tension Check
Spark Plug Check/Clean
Service and maintenance
Daily
•
After fi rst 4 First month /
hrs / weekly 20 hours
•
•
•
•
Every 3 Every 6
months months
/ 50 hrs / 100 hrs
•
•
•
•
13