Using The Timer; Setting The Wake-Up Timer - Pioneer XV-DV99 Mode D'emploi

08

Using the timer

Chapter 8
Using the timer

Setting the wake-up timer

Use the wake-up timer to set the system to
switch on at any time and start playing
whatever source you want.
• The clock must be set to the correct time
for the wake-up timer to work properly
(see Setting the clock on page 19).
56
En
STANDBY/ON STANDBY/ON
CD CD FM/AM FM/AM L1/L2 L1/L2
DVD DVD TUNER TUNER TV TV LINE LINE
DISPLAY OPEN CLOSE
DVD MENU RETURN
TUNE+ TUNE+
ST– ST– ST+ ST+
ENTER ENTER
TUNE– TUNE–
MUTE SOUND
MASTER
VOLUME
TV CONTROL
CH VOL
INPUT
BASS MODE DIALOGUE VIRTUAL SB
AUTO SURROUND ADVANCED
PROGRAM REPEAT RANDOM
AUDIO SUBTITLE ANGLE
HOME
ZOOM TOP MENU MENU
1 2 3
SYSTEM
SETUP TEST TONE CH LEVEL
4 5 6
QUIET/ TIMER/ TIMER/
DIMMER MIDNIGHT CLOCK CLOCK
7 8 9
FOLDER– FOLDER+
0
ENTER
CLR
MAIN SUB
ROOM SETUP
PDP
1 Select the source you want played.
For example, press TUNER to select the radio
as your source.
2 Prepare the source.
For example, tune in the radio station you
want to wake up to.
If you've selected a CD, make sure that it's
stopped.
3 Set the volume.
4 Press TIMER/CLOCK twice to reach the
timer menu.
5 Use the (cursor left/right)
buttons to select 'Wake-Up?' then press
ENTER.
6 Use the (cursor left/right)
buttons to select 'TimerEdit' then press
ENTER.
7 Set the switch-on time.
Use the (cursor up/down) buttons to set
the hour, then press ENTER. Set the minute in
the same way, pressing ENTER when you're
done.
8 Set the switch-off time.
Use the (cursor up/down) buttons to set
the hour, then press ENTER. Set the minute in
the same way, pressing ENTER when you're
done.
After pressing ENTER this last time, the wake-
up indicator lights, and the switch-on, switch-
off times, the function (DVD/CD, etc.) and
volume are confirmed in the display.
9 Switch the system into standby mode.
The wake-up timer will not work if the system
is left on!