Charging The Battery - shark ROCKET IX160 Série Guide D'utilisation

CHARGING THE BATTERY

USING THE LI-ION CHARGER
LI-ION CHARGER
Plug the Li-Ion Charger into a wall outlet.
IN THE VACUUM: MULTIFLEX® WAND
To put the vacuum in storage mode, press the
MultiFLEX Wand Unlock Latch while folding the
handheld vacuum forward until the wand clicks and
locks. Plug the charger into the charging port on the
handheld vacuum.
NOTE: MultiFLEX wand is not included with all configurations. See enclosed Quick Start Guide for your unit's configuration.
s h a r kc l e a n . c o m
IN THE VACUUM: STANDARD WAND
Remove the handheld vacuum from the wand by
pressing the Wand Release Button and pulling
up. Plug the charger into the charging port on the
handheld vacuum.
OUT OF THE VACUUM
To remove the battery, squeeze the Battery Release
Button and slide backwards. Plug the charger into
the charging port on the battery.
OFF
Slide switch to the bottom to turn off power.
To begin vacuuming in Standard Mode, slide switch
to the desired setting.
SETTING II
Carpet
The brushroll spins faster to pick up debris below the
surface of your carpets.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet. The Carpet setting
should also be used when cleaning stuck-on dust and debris.
SETTINGS
SETTING I
Bare Floor/Small Area Rugs
The brushroll spins slowly to clean bare floors and
small area rugs.
BOOST MODE
For an added boost in power, pull the Trigger on
the handheld vacuum. Release it to return to normal
power.
s h a r kc l e a n . c o m