Dock Set-Up; Installing The Side Brushes; Charging Dock Set-Up; Charging The Shark® Ion Robot - shark ION Robot RV750EU Guide D'instructions

INSTALLING THE SIDE BRUSHES

CHARGING DOCK SET-UP

1m
1m
1.6m
• Choose a level surface in a central area.
• Remove any objects that are closer than 1m from either side of the dock,
or closer than 1.6m from the front of the dock.
• Place the dock with its back against the wall, then plug it into a socket.
• The indicator light on the dock will illuminate green when the dock has power.
• The dock must be plugged in continuously for the Robot to find it.
12
sha rkclean.eu

DOCK SET-UP

Attach the two Side Brushes (included) onto the
square pegs on the bottom of the Robot. There is
an additional spare set included in the box.
Firmly press two brushes onto the
square pegs. Save the remaining
brushes for future use.
The space surrounding
the charging dock
is only a guide. The
Robot will often
operate in smaller
spaces, but it is
recommended to give
the Robot a wide
space to allow it to
dock more easily.
CHARGING THE SHARK® ION ROBOT
IMPORTANT: The Shark® ION Robot has a pre-installed rechargeable battery. Battery must be fully
charged before using your Robot. It may take up to 5 hours to fully charge for the first time.
To charge, the Power button on the side of the Robot
must be in the ON position (I).
6
h
If the Robot has no charge and cannot return to the
charging dock, place it on the dock manually and
charge for up to 5 hours.
NOTE: When manually placing the Robot on the dock, make sure the Charging Contacts on the bottom
of the Robot are aligned with the dock. To ensure the Robot is docked correctly, refer to the Charge
Indicator Lights section (see page 14).

CHARGING

When the cleaning cycle is complete, or if the battery
is running low, the Robot will search for the dock.
If your Robot doesn't return to the dock, its charge
may have run out.
s h a r kc l e a n . e u
13