Cameo F4 FC PO IP65 Manuel D'utilisation page 12

Dimmer Curve
Dimmer Response
Red Shift
PWM-Frequency
Color Calibration
Autolock
Fan
Fan
Factory Reset
UC/Loops Reset
12
= Dimmer curve
= Dimmer response
Accurately mimics the
colour drift of dimming a
halogen spotlight. When
dimming the spotlight,
= the colour temperature
changes automatically to
increasingly warm white
and amber (and vice
versa).
= LED PWM frequency
= Colour calibration
Automatic locking of the
=
controls
= Fan setting
= Fan setting
Restore factory settings
= (without resetting user
colours and loops)
Reset the user colours
= and loops to factory
settings
Linear Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX
Exponential
values and broadly adjusted at higher DMX values
Light intensity can be broadly adjusted at lower
Logarithmic DMX values and finely adjusted at higher DMX
values
Light intensity can be finely adjusted at lower and
S-Curve higher DMX values and broadly adjusted at medium
DMX values
LED Light responds abruptly to changes in DMX value
Light behaves like a halogen spotlight with slight
Halogen
brightness changes
No Colour drift is disabled
Dim To Warm Colour drift is enabled
600 Hz / 1200 Hz /
2000 Hz / 4000 Hz / Configuration of LED PWM frequency
6000 Hz / 25k Hz
RAW - Off R, G, B and W with maximum value 255
Press middle encoder = switch between R+G and
RAW - Adjust
B+W (colour) Rotate middle encoder = set value
(Individuelle, betriebs-
of R or B
artübergreifende
Anpassung von R, G, Press right encoder = one level up in menu
B, und W mit Werten structure (ESC)
von jeweils 000 bis Rotate right encoder = set value of G or W
255)
Press left encoder = confirm and save settings
Factory calibration of R, G, B and W (across all
modes). Select this setting for the correct display of
Calibrated colour shades and presets in the standalone modes
CCT and Gel, as well as when controlling CCT and
the presets Gel via DMX.
Smart Calibration Merge Factory (calibrated) and RAW calibration
Automatic locking of the controls after approxima-
tely 30 seconds of inactivity. Display shown upon
On attempted use: "Locked!"
Unlock: Simultaneously press the centre and right
encoders for approx. 3 seconds
Off Automatic locking of the controls is disabled
Auto Automatic fan control
Off Deactivated fan with greatly reduced brightness
Constantly low fan speed with reduced brightness,
Constant Low
if necessary
Constant average fan speed with reduced bright-
Constant Medium
ness, if necessary
Constant High Constant high fan speed
Reset to factory settings:
Reset Now?
confirm with ENTER, cancel with ESC
Reset User Colors/ Reset to factory settings:
Loops confirm with ENTER, cancel with ESC