B&G H1000 Instructions D'installation page 11

All manuals and user guides at all-guides.com
tactical compass function
storing a course
last tack information
When a compass and a wind sensor are connected to the system, the Tactical
Compass function becomes available as a full page display option.
After a tack or gybe, and the yacht is sailing a steady course, press the ENTER
key to store the displayed heading. Note, to access the Main Menu from the
Tactical Compass page, press and hold the ENTER key for two seconds.
Any deviation from the stored course is shown on the screen as a
the corresponding number of degrees.
of the display and head
When the ENTER key is pressed whilst the Tactical Compass page is displayed,
the present heading is automatically stored and the head / lift trend function
reset. When this is done, the display overlays the Heading with Course stored for
two seconds, as shown in the diagram, and the
As soon as heading deviates from the new stored value,
displayed with the number of degrees as appropriate. Resetting the stored
course also updates the Course memory found under the Memories → Compass
menu.
When a tack occurs, the
replaced with the last heading for that tack, providing it was previously stored by
pressing the ENTER key.
Last tack heading remains on screen until the ENTER key is pressed. When
ENTER is pressed, Last Tack information disappears, Course Stored is then
shown for two seconds, and then the appropriate
shown.
www.bandgservice.co.uk
Lift is always shown on the windward side
on the leeward.
head / lift field in the bottom left or right of the display is
lift or
head or lift legends disappear.
head or lift will be
head or lift information is
head with