Cleaning The Filter Element En; Troubleshooting - Abicor Binzel CR1000 Mode D'emploi

CR1000/CR1250
9.2 Cleaning the filter element
The filter has a service life of approx. 500 operating hours and filters a particle size of 70 µm. If there are any visible deposits
on the filter element, it must be cleaned. To clean the filter element, proceed as follows:
1 Filter
Fig. 10 Cleaning the filter element
1 Unscrew the filter cup (4).
2 Remove the filter element (3) and the o-ring (2).
3 Clean the filter element (3) under clean, running water.
4 Insert the filter element (3) and o-ring (2) into the filter cup (4).
5 Screw the filter cup (4) onto the filter.

10 Troubleshooting

DANGER
Risk of injury and device damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorised persons.
• Only qualified personnel are permitted to perform work on the device or system.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems, please contact your retailer
or the manufacturer.
NOTICE
• Also observe the operating instructions for the welding components and welding torch.
BAL.0351.0 • 2020-06-10
1
2
3
4
2 O-ring 3 Filter element 4 Filter cup
10 Troubleshooting
EN - 15