Qilive Q.6822 Manuel D'utilisation page 9

Note: Figures 1 and 2 only illustrate the space demand of the product.
3. Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it
will give rise to vibration and noise. When the refrigerator is placed on such flooring
materials as carpet, straw mat, polyvinyl chloride, the solid backing plates should
be applied underneath the refrigerator, so as to prevent color change due to heat
dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an
embedded structure.
4.2. PREPARATIONS FOR USE
Leveling
1.
Make sure to level your refrigerator/freezer using the front leveling feet. If not level, the
door gasket sealing performance will be affected, or even it may lead to the operating
failure of your refrigerator/freezer.
Cleaning
2.
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
3. Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on
immediately. Make sure to energize the refrigerator after more than 1 hour's standing,
so as to ensure its normal operation.
4. Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open
the refrigerator door, if the temperature inside the refrigerator compartment drops
obviously, it indicates the refrigeration system is working normally.
5. Storage of food
After the refrigerator runs for a period of time, the internal temperature of the
refrigerator will be automatically controlled according to the user's temperature setting.
After the refrigerator is fully cooled, put in foods, which usually need 2~3 hours to be
fully cooled. In summer, when the temperature is high, it takes more than 4 hours for
the foods to be fully cooled (Try to open the refrigerator door as less as possible before
the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check
whether the ground wire and leakage circuit breaker are normal. If vibration
noises are produced due to the refrigerator contacting the wall or if the
wall gets blackened by air convection around the compressor, move the
refrigerator away from the wall. Setting up the refrigerator may cause jamming
noise or image chaos to the mobile phone, fixed-line telephone, radio receiver,
television surrounding it, so try to keep the refrigerator as far away as possible
in such case.
Figure 1
9
Figure 2
EN