Publicité
Les langues disponibles
Les langues disponibles
Guide the wires from the conduit cable (coming from
3.
the speed oven or steam convection oven through the
hole in the oven-mounted junction box. (See image
below). There are four wires from a speed oven or
three wires from a steam convection oven--no white
wire from a steam convection oven.
Snap the conduit connector into the hole by pressing it
4.
in until it clicks into place.
Follow the wiring diagram label (see image below) and
5.
match and connect each wire by color to the wires
attached to the wiring block inside the oven-mounted
junction box. Push the bare end of the wire until it is
snug in the wiring block then tighten down the
retaining screw on each wire.
Tighten securely, but do not overtighten.
See previous illustration in Step 3 for finished
appearance.
12
Replace the oven-mounted junction box cover and
6.
tighten the two screws holding it in place.
Tighten securely, but do not overtignten.
Microwave Models
Microwave Models HBL57M52UC, HBL87M52UC
Microwave Combo has a 120 Volt receptacle.
Note: 120V receptacle is to be used as the power
supply for HMB50152UC microwave.
Installation of Microwave to the Combination Oven
For microwave models HBL57M52UC, HBL87M52UC
see previous Installation Chapter.
Publicité
