Publicité
Les langues disponibles
Les langues disponibles
Installing or removing driver bit or socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
1
2
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original posi-
tion and the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
Hook
3
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool hous-
ing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
001266
9 mm
(3/8")
001267
1. Bit
2. Sleeve
006592
1. Screw
2. Hook
3. Groove
2
1
OPERATION
1
CAUTION:
•
Never obstruct the air vents on the side of the tool
for cooling down oil unit and motor during opera-
tion. Failure to do so may cause the tool excessive
hotness and damage.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N m
(ft lbs)
30
(306)
20
(204)
M6
10
(102)
0
0.5
Fastening time (S)
6
006843
1. Air vents
2. Cooling down oil
unit
2
006841
M10
M8
1.0
Publicité
