Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ERROR TYPE
SR – Set value
Blink on cooler
set value
screen
SR – Set value
blink on freezer
and cooler set
value screen
SR – Set value
blink on cooler
set value
screen
"--"
If your fridge is not operating;
• Is there a power failure?
• Is the plug connected to the socket correctly?
• Is the fuse of the socket to which the plug is connected or the main fuse blown?
• Is there any failure at the socket? To check this, plug your refrigerator to a socket this
is surely operating.
If your fridge is not cooling enough;
• Is the temperature adjustment right?
• Is the door of your fridge opened frequently and left open for a long while?
• Is the door of fridge closed properly?
• Did you put a dish or food on your fridge so that it contacts the rear wall of your fridge
so as to prevent the air circulation?
• Is your fridge filled excessively?
• Is there adequate distance between your fridge and the rear and side walls?
• Is the ambient temperature within the range of values specified in the operating manual?
MEANING
"Refrigerator
comp.
Not Cold enough"
"not cold enough
Warning"
Refrigerator
comp. too Cold
"Low voltage
Warning"
WHY
Ideal temperature for
Ref. Compartment is
+4
C. If you see this
o
warning your foods
have risk of spoiling.
It is combination of
"not cool enough"
error for both of the
compartments.
The foods starts to
freeze because of
the too much cold
temperature
When the power
supply gets lower
than 170 V the
appliance gets to
steady position.
EN -23-
WHAT TO DO
1. Set the refrigerator
temperature to colder
values or set the super
cooling mode until the
compartment gets to
normal temperature.
2. Do not open the door
much until this failure is
off.
You will see this failure
when first starting the
appliance. It will be off
after the compartments
gets normal temperature
1. Check if the "Super
cooling mode" is on
2. Decrease the
refrigerator temperature
values
This is not a failure. This
prevents any damages
on the compressor. This
warning will off after the
voltage gets required level
Publicité
Chapitres
Table des Matières
