Hikmicro LYNX Serie Guide Demarrage Rapide page 50

For proper recycling, return the battery to your
supplier or to a designated collection point. For
more information see: www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-003 (B)/NMB-003(B)
standards requirements.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radioexempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled
environment.
ce matériel est conforme aux limites de dose
d'exposition aux rayonnements, CNR-102 énoncée dans
un autre environnement.
KC
B급 기기: 이 기기는 가정용(B급)
전자파적합기기로써 주로 가정에서 사용하는 것을
목적으로 하며, 모든 지역에서 사용할 수 있습니다.
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
Laws and Regulations
● Use of the product must be in strict compliance with
the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while
transporting it.
● Keep all wrappers after unpacking them for future
use. In case of any failure occurred, you need to return
the device to the factory with the original wrapper.
● Transportation without the original wrapper may
result in damage on the device and the company shall
not take any responsibilities.
● Do not drop the product or subject it to physical
shock. Keep the device away from magnetic
interference.
Power Supply
● The Input voltage should meet the Limited Power
Source (5 VDC, 2 A) according to the IEC62368-1
standard. Please refer to technical specifications for
detailed information.
● Make sure the plug is properly connected to the
power socket.
● DO NOT connect multiple devices to one power
adapter, to avoid over-heating or fire hazards caused
by overload.
● Use the power adapter provided by qualified
manufacturer. Refer to the product specification for
detailed power requirements.
Battery
● The built-in battery type is 18650, and the battery
size should be 24 mm × 72 mm. The rated voltage and
capacity are 3.635 VDC/3350 mAh.
● Use the battery provided by qualified manufacturer.
Refer to the product specification for detailed battery
requirements.
● The built-in battery cannot be dismantled. Please
contact the manufacture for repair if necessary.
● For long-term storage of the battery, make sure it is
fully charged every half year to ensure the battery
quality. Otherwise, damage may occur.
● Use the battery provided by qualified manufacturer.
Refer to the product specification for detailed battery
requirements.
● CAUTION: Risk of explosion if the battery is replaced
by an incorrect type.
● Improper replacement of the battery with an
incorrect type may defeat a safeguard (for example, in
the case of some lithium battery types).
● Do not dispose of the battery into fire or a hot oven,
or mechanically crush or cut the battery, which may
result in an explosion.
● Do not leave the battery in an extremely high
temperature surrounding environment, which may
result in an explosion or the leakage of flammable
liquid or gas.
● Do not subject the battery to extremely low air
pressure, which may result in an explosion or the
leakage of flammable liquid or gas.
● Dispose of used batteries according to the
instructions.
Maintenance
● If the product does not work properly, please contact
your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance.
● Wipe the device gently with a clean cloth and a small
quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
device may be impaired.
Using Environment
● Make sure the running environment meets the
requirement of the device. The operating temperature
shall be -20 °C to 55 °C (-4 °F to 131 °F), and the
operating humidity shall be 95% or less.
● Place the device in a dry and well-ventilated
environment.
● DO NOT expose the device to high electromagnetic
radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright
light.
Emergency
● If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power
cable, and contact the service center.
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road, Xixing
Subdistrict, Binjiang District, Hangzhou, Zhejiang
310052, China
Hangzhou Microimage Software Co., Ltd.
COMPLIANCE NOTICE: The thermal series products
might be subject to export controls in various countries
or regions, including without limitation, the United
States, European Union, United Kingdom and/or other
member countries of the Wassenaar Arrangement.
Please consult your professional legal or compliance
expert or local government authorities for any
necessary export license requirements if you intend to
transfer, export, re-export the thermal series products
48