CERTIFIED 060-0190-2 Guide D'utilisation page 21

20
model no. 060-0190-2
To clean a flooded engine
NOTE: if the engine won't start after you have pressed the starter several times, the
engine may be flooded with excess fuel. Use following procedure to clear and start a
flooded engine.
1. Release the engine start/stop lever to stop engine.
2. Remove the spark plug, dry it, and then
reinstall it.
(1) Remove the spark plug cover (see Fig. 20).
(2) Use the spark plug socket wrench to
remove the spark plug (see Fig. 20-1).
(3) After drying, replace the spark plug.
NOTE: Install the spark plug carefully by hand, to avoid cross-threading. After the plug is
seated, tighten 1/8 to 1/4 turn with the spark plug socket wrench to compress the washer.
3. Pull the engine start/stop lever toward upper handle.
4. Operate the starter as described above.
Mowing
WARNING: Always observe the strictest safety procedures when using the lawnmower.
Carefully read the safety instructions of this manual before using the lawnmower.
WARNING: Never open the ejector flap when the grass bag has been detached (to be
emptied) and the engine is still running. The rotating blade can cause serious injuries!
I
contact us: 1-844-428-7277
Fig. 20
Fig. 20-1