AVS Bugflector Serie Instructions D'installation page 2

Installation Steps
For 2003-05 models: Loosen, but do not remove, (7)
nuts securing grill to hood.
3
Lower the hood, and pivot the grill forward to create
a 1/4" (.6 cm) gap between hood and grill.
4
Attach fasteners to hoodshield by inserting screw through washer,
then through hood shield, and into well nut. Partially thread screw
into well nut.
Well nut
Hood shield
Washer
6
Raise hood again. Align fastener previously installed
in hoodshield with hole in passenger side of the
hood. Insert fastener in hole and tighten. Repeat for
8
NOTE: Actual application may vary slightly from illustrations.
opposite side.
For 2006-08 models: Loosen, but do not remove, (8)
or
Locate (2) outboard holes on on each end of hoodshield.
5
Slide the hood shield between the hood and grill, and center.
7
Realign grill, and retighten (7) previously loosened
9
Page 2 of 3
nuts securing grill to hood.
.
screws