Publicité
Les langues disponibles
Les langues disponibles
INsTALLATIoN
Installation
1
2
1 Through hole for locking screw
2 Locking screw
f Mark out the hole to be drilled for the locking screw. Use the
f
through hole in the lower section of the appliance casing as a
template for this purpose.
f Remove the appliance from the wall mounting bracket.
f
f Drill the hole for the locking screw. Insert a suitable rawl
f
plug.
f Hang the appliance as described on the wall mounting
f
bracket.
f Secure the appliance with a suitable screw.
f
10.3 Fitting the towel holder (accessory)
f Carefully pull the ends of the towel holder apart.
f
1 Towel holder mounts
f Insert the left and right-hand ends of the towel holder into
f
the mounts provided for this purpose at the back of the
appliance.
16
| CK 20 trend
1
1 Towel holder, installed
CAUTION Injury
!
- Never hang any heat-sensitive or highly flammable
materials (e.g. textiles made of silk, wool or syn-
thetic fibre, paper) over the towel holder.
- Only heat/dry textiles that have been washed in
water (not dry cleaning).
10.4 Power supply
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
Material losses
!
1
The specified voltage must match the mains voltage.
f Observe the type plate.
f
The appliance is supplied fully wired (with a mains plug), but it is
also suitable for permanent connection.
10.4.1 Connection to a socket
Material losses
!
The power cable must not hang in front of the air dis-
charge.
f Wind up any surplus power cable and stow it in the
f
cable compartment at the back of the appliance.
1 Cable compartment
f Insert the power plug of the appliance into a suitable socket.
f
1
www.stiebel-eltron.com
Publicité
