Publicité
Les langues disponibles
Les langues disponibles
PC interface
The Beurer blood pressure monitor also allows you to trans-
fer your measured values to the PC.
To do this you require a USB cable (included in delivery) and
the Beurer "Health Manager" PC software.
The software can be downloaded free of charge from the
download area under Service at www.beurer.com.
System requirements for the Beurer "Health Manager"
computer software
1. Supported operating systems:
• Windows XP SP3
• Windows Vista SP1 or later
• Windows 7
• Windows 7 SP1
• Windows 8
2. Supported architectures:
• x86 (32 bit)
• x64 (64 bit)
3. Hardware requirements:
• Recommended: at least Pentium 1 GHz or faster with at
least 1 GB RAM
• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Graphic resolution from: 1024 x 768 pixels
• USB port 1.0 or later
4. Prepare measurement
Inserting battery
• Push the cuff holder
upwards at the rear of the
device until it locks into
place.
• Open the battery com-
partment lid.
• Insert four AA 1.5 V alka-
line batteries. making absolutely sure that you insert them
with the correct polarity as marked. Never use recharge-
able batteries.
• Replace the battery cover carefully.
If the battery change
measurement is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset.
Used batteries do not belong in the household waste. You
are legally obliged to dispose of the batteries. Dispose of
them via your specialist electrical supplier or local collec ting
point for recyclable waste.
22
is continuously illuminated,
Publicité
