Publicité
Les langues disponibles
Les langues disponibles
3. Package contents
A
N
See fig.
-
4. Safety
4.1 Proper intended use
This product serves as a separation between the boot and the passenger compartment.
This product is intended for private use only
Only use this product as described in these operating instructions. Any other use is considered improper and may result
in property damage or even personal injury.
The manufacturer or dealer accepts no liability for damage caused by improper or incorrect use.
4.2 Safety instructions
Warning
Risk of death!
In the event of sudden braking manoeuvres or an accident, objects and/or pets may fly through the interior
and cause serious or fatal injuries.
→ Always secure all objects in the vehicle additionally in the boot.
→ When the vehicle is in motion, no persons may be behind this product.
→ Pets must always be additionally secured (box, belt, ..).
Warning
Risk of injury!
Incorrect mounting of the product can lead to personal injury.
→ When mounting, make sure that all screws are properly tightened and that no parts can come loose.
→ Never use the product to separate the front seats from the rear seats.
→ Make sure that the head restraints are always used at the correct height.
Notice
Risk of damage!
Improper use of the product may result in damage to the vehicle or the product.
→ Only use the correct size for your vehicle.
→ Only use the product if the head restraints of the vehicle can be removed.
5. Use
Check the product for completeness (
1
Remove the outer two head restraints.
2
Select the correct size of bushes
loop F over the other headrest rods. Make sure that the whistles B point in the same direction for both head restraints.
Insert the head restraints again.
3
E
Pull the clips
together with the hexagonal bars
4
Select the optimum angle of inclination.
5
M
Fix the screws
and nuts
6
Thread the safety loops
7
Insert the retaining clip
8
Place the partition grid/partition net
vehicle. Tighten the locking screws
I
the allen key
.
9
Fix the allen screws
When the product is not in use, it can be folded down.
Remove the partition grid/partition net
C2
screws
.
6. Cleaning
Clean the product with a damp cloth. Do not use aggressive cleaning agents.
6
Read the user instructions.
A
N
-
).
D
and pass them over the headrest rods together with the pipes
L
using allen key
F
into the clamps
G
E
into the clip
.
A
on the pipes
C2
on the hexagonal bars
N
to the headrest bar with the allen key
A
when one half of the rear bench seat is folded down by loosening the locking
C
over the whistles
I
. Tighten the screws
E
and tighten them firmly.
B
. Centre the partition grid/partition net
E
. Now tighten the screws
H
.
B
. Select the optimum distance.
M
only slightly.
M
B
. Guide the safety
A
and align it to fit your
L
and nuts
firmly using
Publicité
