AEG BBS 1100 Instructions D'utilisation page 4

Switching the
machine on and
off
Advice for
operation
Dust extraction
Maintenance
Accessories
3
ENGLISH
All manuals and user guides at all-guides.com
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and
then the locking button, after that release
on-off switch.
Switching off: Press the On-/off switch and
then release.
Always hold machine firmly with both hand
prior to switching on. Only switch on in
raised position.
When sanding, guide the machine without applying special pressure. The weight of
the machine itself is quite sufficent for good sanding results.
When sanding wood, the dust bag should
be used.
When suction performance becomes less
effective empty dust bag.
If large quantities of dust are being
produced, a hose-pipe can be connected
to the dustbag connector.
When sanding metal the dust suction
facility should not be used, because of the
risk of fire from flying sparks.
The ventilation slots of the machine must be kept clear at all times.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at:
The range of accessories with part numbers is shown in our catalogue.
.
2
1
BBS 1100, BBSE 1100