Wahl 7061 Serie Mode D'emploi page 8

EN
CLEANING & OILING TRIMMER BLADES
Clean with the included brush. For best results, put one or two drops of Wahl Clipper Oil
on the blades only when necessary, or approximately once a month. Motor bearings are
permanently lubricated—do not attempt to oil.
When oiling your trimmer, turn the trimmer "ON - I," hold the unit with the blades facing
DOWN and squeeze one or two drops of oil onto the blades. Wipe off excess oil with
soft cloth.
STORAGE
Before storing your trimmer, use the cleaning brush to whisk any loose hairs from the
unit, foils, cutter bar, and blades. Store unit in such a manner so that blades are protect-
ed from damage.
When the shaver is not in use, the shaver foil/blade guard attachment should be in place
to protect the blades.
This appliance should be stored in a manner where it is not subjected to Crushing,
Heating above 100°C (212°F), or Incineration.
CORD CARE
The cord should not be used to pull the shaver. Freedom of movement needs to be
maintained. Care should be used to keep the cord untwisted and undamaged.
When stored, the cord should be coiled and replaced neatly in its original package or
storage pouch.
WET/DRY USE
NOTE: Do not submerge shaver in more than 3 feet of water or for more than 30 minutes
to prevent water ingress into the electronics. Warranty is void if shaver is submerged
beyond these limitations.
The Wahl shaver is designed to be water resistant and shower proof (IPX7). This lets you
use your Wahl shaver in the shower or at the sink without worry and makes it easy to
clean under running water.
NOTE: The shaver is for wet/dry use. For safety, the shaver will not run while the cord is
attached.
8